Açıklama

HPE Aruba 2530 48G J9853A PoE Switch

Özellikler

Teknik Özellikler

Cost-effective, reliable and secure Aruba Layer 2 switch series.
ACLs, EEE, traffic prioritization and models with 10 Gigabit uplinks.
8-, 24-, and 48-port Gigabit or Fast Ethernet models.
PoE+ models for voice, video and wireless.
Supports ClearPass Policy Manager and Airwave Network Managemen

J9853A
Type	Aruba 2530-48G-PoE+-2SFP+ Switch
System specifications
Ports	48 RJ-45 autosensing 10/100/1000 PoE+ ports (IEEE 802.3 Type 10BASET,IEEE 802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T, IEEE802.3at PoE+); Media Type: Auto-MDIX; Duplex: 10BASE-T/100BASE-TX:half or full; 1000BASE-T: full only;
	2 SFP+ fixed 1000/10000 SFP+ ports;
	1 dual-personality (RJ-45 or USB micro-B) serial console port.
Memory and processor	ARM9E @ 800 MHz, 128 MB flash, 256 MB DDR3DIMM; packet buffer size: 3 MB
Mounting	Mounts in an EIA-standard 19-inch telco rack or equipment cabinet (rack mounting kit available); horizontal surface mounting; wall mounting.
Management	IMC - Intelligent Management Center; command-line interface; Web browser; configuration menu; out-of-band management (serial RS-232C or Micro USB); IEEE 802.3 Ethernet MIB; Repeater MIB; Ethernet Interface MIB
Performance (IPv6 Ready Certified)
100 Mb Latency	< 7.3 µs (LIFO 64-byte packets)
1000 Mb Latency	< 2.7 µs (LIFO 64-byte packets)
10 Gb/s Latency	< 4.0 µs (LIFO 64-byte packets)
Throughput	Up to 101 million pps (64-byte packets)
Switching capacity	136 Gb/s
MAC address table size	16000 entries
Physical specifications
Dimensions (W x D x H)	44.3 x 32.26 x4.45 cm (17.44 x 13.00 x 1.75 in) (1U height)
Weight	4.72 kg (10.4 lb)
Electrical specifications
Maximum heat dissipation	215 BTU/hr (226.83 kJ/hr), (switch only: 215BTU/hr; combined switch + max. PoE devices:1499 BTU/hr)
Voltage	100 - 127 / 200 - 240 V ac
Current	5.6/2.8 A
Idle power1	40.2 W
Maximum power rating2	439 W
PoE power	382 W
Frequency	50/60 Hz
NOTE: 1: Idle power is the actual power consumption of the device with no ports connected 2: Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. PoE power is the total power budget available to all PoE ports.
Environmental specifications
Operating temperature	° to 45°C (32° to 113°F)
Operating relative humidity	15% to 95% @ 40°C (104°F), noncondensing
Non-operating/storage temperature	-40° to 70°C (-40° to 158°F)
Non-operating/storage relative humidity	15% to 90% @ 65°C (149°F), noncondensing
Altitude	Up to 3 km (10,000 ft)
Acoustic	Power: 36.4 dB, Pressure: 30.1 dB
Safety agency certifications
Safety	UL 60950-1; CAN/CSA 22.2 No. 60950-1; EN 60825; IEC 60950-1; EN60950-1
NOTE: IEEE 802.3az applies to Gigabit models only; IEEE 802.3at and IEEE 802.3afapply to PoE+ models only. SFPs with revision "B" or later (e.g., J4858B, J4859C) are required with this product. This product supports only 1 Gigabit SFP & 10 Gigabit SFP+ transceivers, as well as 10 Gigabit Direct Attach Cables.