Ürün arama
Açıklama
Huawei S3700 52P PWR EI 10/100 PoE Switch
Özellikler
- 48*10/100Base-TX ports, 2*100/1000Base-X SFP ports, 2*1000Base-X SFP ports
- Layer 3 Ethernet Switch
- Dual slots of power, without power module
- Software: Enhanced Version
- S3700-52P-PWR-EI supports multicast routing features and intelligent stacking (iStack)
Teknik Özellikler
Item | Description |
Fixed port | 48*10/100Base-TX ports, 2*100/1000Base-X SFP ports, 2*1000Base-X SFP ports |
Forwarding performance | 13.2 Mpps |
MAC address table | Supports IEEE 802.1d compliance. |
Supports 16K MAC address entries. | |
Supports MAC address learning and aging. | |
Supports Static, dynamic, and blackhole MAC address entries. | |
Packet filtering based on source MAC addresses | |
VLAN features | Supports 4K VLANs |
Supports Guest VLANs, voice VLAN, and super VLAN | |
Supports VLAN assignment based on MAC addresses, protocols, and IP subnets | |
Supports QinQ | |
Supports Selective QinQ | |
Supports 1:1 VLAN mapping | |
Supports N:1 VLAN mapping | |
Reliability | Supports RRPP (ring topology, intersecting rings, and multi-instance), implementing protection switchover within 50 ms |
Supports Smart Link tree topology and Smart Link multi-instance, providing the millisecond-level protection switchover | |
Supports STP(IEEE 802.1d), RSTP(IEEE 802.1w), and MSTP(IEEE 802.1s) | |
Supports BPDU protection, root protection and loop protection | |
Supports Smart Ethernet Protection (SEP) | |
BFD for OSPF, BFD for IS-IS, BFD for VRRP, and BFD for PIM | |
IP routing | Supports Static routing, RIPv1, RIPv2, and ECMP |
OSPF, IS-IS, and BGP | |
IPv6 features | Supports Neighbor Discovery (ND) |
Supports Path MTU (PMTU) | |
Supports IPv6 ping, IPv6 tracert, and IPv6 Telnet | |
Supports Manually configured tunnel | |
Supports 6 to 4 tunnel | |
Supports ISATAP tunnel | |
Supports ACLs based on source IPv6 address, destination IPv6 address, Layer 4 ports, or | |
protocol type | |
Supports MLD v1/v2 snooping | |
Multicast | Supports 1 K multicast groups |
Supports IGMP v1/v2/v3 snooping and IGMP fast leave | |
Supports Multicast VLAN and multicast replication between VLANs | |
Supports Multicast load balancing among member ports of a trunk | |
Supports Controllable multicast | |
Supports Port-based multicast traffic statistics | |
IGMP v1/v2/v3, PIM-SM and PIM-SSM | |
QoS/ACL | Supports Rate limiting on packets sent and received by an interface |
Supports Packet redirection | |
Supports Port-based traffic policing and two-rate three-color CAR | |
Supports Eight queues on each port | |
Supports WRR, DRR, SP, WRR+SP, and DRR+SP queue scheduling algorithms | |
Supports Re-marking of the 802.1p priority and DSCP priority | |
Supports Packet filtering on Layers 2 through 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination | |
Supports IP address, port number, protocol type, and VLAN ID | |
Supports Rate limiting in each queue and traffic shaping on ports | |
Security & access | Supports User privilege management and password protection |
Supports DoS attack defense, ARP attack defense, and ICMP attack defense | |
Supports Binding of the IP address, MAC address, interface, and VLAN | |
Supports Port isolation, port security, and sticky MAC | |
Supports Blackhole MAC address entries | |
Supports Limit on the number of learned MAC addresses | |
Supports 802.1x authentication and limit on the number of users on an interface | |
Supports AAA authentication, RADIUS authentication, HWTACACS authentication, and NAC | |
Supports SSH v2.0 and CPU defense | |
Supports Blacklist and whitelist | |
Supports DHCP Server, DHCP Relay, DHCP Snooping, DHCP Security | |
Surge protection | 6KV surge protection capability on service ports (1KV on service ports on PoE devices) |
Management and maintenance | Supports iStack and MAC Forced Forwarding (MFF) |
Supports Remote configuration and maintenance using Telnet | |
Supports Auto-Config.and Virtual cable test | |
Supports Ethernet OAM (IEEE 802.3ah and 802.1ag) | |
Supports SNMP v1/v2c/v3 and RMON | |
Supports MUX VLAN,GVRP and Web NMS | |
Interoperability | Supports VBST (Compatible with PVST/PVST+/RPVST) |
Supports LNP (Similar to DTP) | |
Supports VCMP (Similar to VTP) | |
Operating environment | Operating temperature: 0°C to 50°C(long term); |
Relative humidity: 10%–90% (non-condensing) | |
Power supply | AC: |
Rated voltage range: 100 V to 240 V AC; 50/60 Hz | |
Maximum voltage range: 90 V to 264 V AC; 50/60 Hz | |
Dimensions (mm) | 442 (W) x 420 (D)x 43.6 (H) |
Weight | < 4.3Kg(without power supply) |
Power consumption | < 880W(PoE: 740W) |
Huawei S3700 52P PWR EI 10/100 PoE Switch Pdf Dosyası811.83 KB
Teknik Kısa
PoE : PoE
Port Hızı : 100 Mbps
Yönetilebilirlik : Yönetilebilir Layer 3
Aktarım Port Sayısı : 4
Aktarım Türü : Gbit Fiber
PoE Port Sayısı : 48 Port
PoE Güç Bütçesi : 400-800 Watt